80kw natural gas generator from China famous gas generator factory
Requirement for natural gas
1.Within 1m from pressure regulating valve of gas intake.
2.the ratio of CH4. in natural gas not less than 70%.
3.Pressure of natural gas 80-200kpa,Rate of pressure change≤1kpa/min
4. H2S≤200mg/Nm³
5.Moisture content≤40g/N m³
6.Impurity particle size≤5μm, impurity content≤30g/N m³
7. If fuel gas contains higher quantity of sulfur and ammonia ,it will not only corrode the pole of sparking plug seriously but also increase the acid value of engine oil which will corrode the parts inside of genset, easy to generation sediment and increase the attrition corrosion to the engine.
Main Specification
Technical Parameters of 80kw Natural gas genset
Requirement for natural gas
1.Within 1m from pressure regulating valve of gas intake.
2.the ratio of CH4. in natural gas not less than 70%.
3.Pressure of natural gas 80-200kpa,Rate of pressure change≤1kpa/min
4. H2S≤200mg/Nm³
5.Moisture content≤40g/N m³
6.Impurity particle size≤5μm, impurity content≤30g/N m³
7. If fuel gas contains higher quantity of sulfur and ammonia ,it will not only corrode the pole of sparking plug seriously but also increase the acid value of engine oil which will corrode the parts inside of genset, easy to generation sediment and increase the attrition corrosion to the engine.
Main Specification
Model | Engine No. | Rated power | Rated speed( r/min) | Size(mm) | Net weight(KG) |
CW-80GFT | CW6135 | 80KW | 1500 | 4000×120×1750 | 2300 |
CW-100GFT | CW6135 | 100KW | 1500 | 4000×120×1750 | 2300 |
CW-120GFT | CW12V135 | 120KW | 1500 | 4000×120×1750 | 4000 |
Technical Parameters of 80kw Natural gas genset
Genset No. | CW-80GFT |
Engine No. | CW6135 |
Type | outside |
Rated power | 80kw |
Rated voltage | 400V/230V/380V/220V |
Phase | 3P4W |
Rated Frequency | 50Hz |
Rated speed | 1500r/min |
Rated power factor | 0.8 |
Rated current | 144 A |
Heat consumption | ≤11.5mj/kw.h |
Pressure | 3-20kpa |
Cylinder No. | 6 |
Cylinder diameter | 135mm |
Stroke | 150mm |
Compression ratio | 10:1 |
Intake mode | Natural intake |
Sparking mode | Spark plug |
Voltage regulation mode | automatic |
Speed regulation mode | Electric speed regulate |
Lubrication mode | Pressure and splash |
Cooling mode | Circulating water cooled |
Start mode | 24V electric motor |
Overhaul time | ≥25000h |
Noise | ≤105 |
Exhaust temperature | ≤650ºC |
Displacement | 10.4L |
Size | 4000×1200×1750 |
Weight | 2300kg |